Operating Instructions Dishwasher GV561D10 Main power switch SpeedWash Programme selector Auto open Auto wash Half load Intensive wash Delayed start Eco wash Display Glass wash Rinse aid indicator 1 hour wash Salt indicator Safety instructions ........... 2 Before washing for the first time ......3 Loading the dishwasher ..........
Safety instructions Winter storage/transport General • • Store the dishwasher where the temperature remains Read the operating instructions and keep them above freezing. in a safe place! • Avoid long transport distances in very cold weather. • Never use the dishwasher for any purpose other •...
Before washing for the first time The water softener Refill salt indicator When the salt needs topping up, the above symbol lights In order to achieve good dishwashing results, the on the display. dishwasher needs soft water (water with low mineral content).
Page 4
Settings Open the settings menu: 1. First, open the door. Turn on the machine. Press and hold the main power switch until the display lights 2. Within 10 seconds: - press the Programme selector and the option button for Speed Wash at the same time. 3.
Page 5
of pots and pans. Make sure the cup shelf is on the correct Economic dishwashing position when folded up as show in the picture. • Do not start the dishwasher until it is fully loaded to save energy. • Do not rinse under running water. Simply scrape off large food particles before loading the dishwasher.
Cup shelf Loading the dishwasher of pots and pans. Make sure the cup shelf is on the correct position when folded up as show in the picture. The dishwasher's baskets(EN60436) The dishwasher is equipped with a top cutlery tray, an upper basket and a lower basket.
Using the dishwasher Add detergent Too much detergent can result in less effective Add the detergent to the detergent compartment. dishwashing and also entails greater environmental 1: Please choose an open way according to the actual impact. lid is tight and will not open correctly. situation.
Page 8
Close the door and the dishwasher counts down 1 hour at a time and starts after the selected delay. Auto wash If you want to cancel the Delayed start option, open the door and The dishwasher can measure how dirty the dishes are and press and hold the main power switch until the display turns off.
Page 9
Programme chart(EN60436) PROGRAMS Detergent, EXTRA Prewashes Main wash Number of Final rinse Consumption values compartment 1 rinses - Program - Options Dishwashing Energy Water cons. time (approx. (ml) (approx. kWh) hrs:min) Auto wash 4 / 15 60 ° C 1:20-2:30 0.790-1.510 9.8~13.1 Prewash(45℃)
Settings Open the settings menu: 1. First, open the door. Turn on the machine. Press and hold the main power switch until the display lights 2. Within 10 seconds: - press the Programme selector and the option button for Speed Wash at the same time. 3.
Page 11
Settings Options 2. TAB 3:00 (Off) You can activate this setting when using 3-in-1/ (3-in-1/all-in-one detergent) 3:01 (On) All-in-one detergent. The dishwashing programmes automatically adapt to provide the best possible dishwashing and drying results every time. If this setting is activated there is no need to add rinse aid since this option disables rinse aid dispensing.
Care and cleaning Filter System The filter prevents larger remnants of food or other objects from getting inside the pump. The residues may block the filter, in this case they must be removed. Fine filter. This filter holds soil and food residues in the sump area prevents them from being redeposited on the dishes during wash cycle.
Page 13
2 Unscrew the spray arm bearings counterclockwise to Spray arms remove the spray arm from the upper basket. Holes and bearings can sometimes become blocked. Remove any debris using a pin or the like. The spray arms also have holes underneath. Door When cleaning the edge around the door, use only a slightly To facilitate cleaning you can remove the spray arms.
Troubleshooting Type of fault on the display Action Water Inlet Fault Check that the water tap is on. Check that the outer filter on the inlet hose is not blocked. If the problem persists, call the service department. Not reaching required Call the service department.
Page 15
Problem Possible causes Action The dishes are not clean. The spray arms do not rotate. Remove the arms and clean them. Check that the dishes are not blocking the spray arms. Old detergent. Detergent is a perishable Avoid large packages. product.
Page 16
Problem Possible causes Action The dishes are not correctly placed or Check that the dishes are placed Rattling sound when dishwashing. the spray arms are not rotating. securely. Spin the spray arms to make sure they can rotate. Loosen the drainage hose where it Water remains in the dishwasher.
Installation Setup It is important that you read through and follow the instructions and directions below. Conduct installation and • The recess and connection dimensions are included in connection in accordance with the separate installation the separate installation instructions. Check that all instructions.
Service Read the chapter Troubleshooting before contacting the service department. Provide the details on the serial number When the drainage hose is routed to a connection plate in all contact. Include the article number (1) and the nipple on the sink unit's water trap (see illustration 1), serial number (2).
Information for test institute Request test institute information via e-mail dishwashers@appliance-development.com. The request should include the details on the serial number plate. Include the article number (1) and the serial number (2).
Page 20
Information on energy labelling(EN60436) Information sheet, in compliance with Commission Delegated Regulation (EU) No. 1059/2010 Gorenje Model designation: GV561D10 Number of standard place settings: Energy efficiency class: 72 kWh Energy consumption/100 cycles: Energy consumption of the standard cleaning cycle(E ):0.719 kWh Power consumption 0.45 W...
Need help?
Do you have a question about the GV561D10 and is the answer not in the manual?
Questions and answers