Hardware Installation And Pc Setup; Overview; Connecting The Hardware - Paradyne 6212 User Manual

Hardware Installation and
PC Setup

Overview

This chapter provides basic instructions for connecting the router to a computer or
a LAN and to the Internet using DSL. The first part provides instructions to set up
the hardware, and the second part describes how to prepare your PC for use with
the router. Refer to
instructions.
It is assumed that you have already subscribed to DSL service with your telephone
company or other Internet service provider (ISP).

Connecting the Hardware

Shut down your PC before connecting the router. To connect your router:
Procedure
6212-A2-GB22-00
Chapter 3, Using the Web Interface
1. Connect the supplied modular phone cable to the LINE port, and connect the
other end of the cable to your phone jack.
2. If you would like to use a phone in the vicinity of the router, connect it to the
PHONE jack of the router using the cord that came with your telephone. The
router has an internal POTS filter, so you do not need to install one here.
3. Use the included Ethernet cable to connect your computer to the router. Attach
one end of the Ethernet cable to one of the LAN ports on the back of the router
and connect the other end to the Ethernet port or Network Interface Card
(NIC) in your PC.
Connect any other PCs, hubs, and switches to the remaining LAN ports. Either
a crossover or a straight-through Ethernet cable can be used: the router
determines and adjusts to the type of signal required.
4. Connect the cylindrical power plug into the POWER connector on the back of
the device. Next:
— If you have a wall-mount adapter, plug the AC adapter into a wall outlet or
a power strip.
— If you have a table-top adapter, use the AC power cord to connect the
adapter to a wall outlet or power strip.
January 2005
2
for router configuration
2-1