Tape-To-Tape Recording - Panasonic SC-AK17 Operating Instructions Manual

1
2
4
1
2
3
4
2
3
Tape direction of the tape
you are recording onto

Tape-to-tape recording

The recording level and the Dolby effect (except for SC-AK17 models
and SC-AK27 Australia and New Zealand model) will be recorded as
they are on the tape being played back.
Press [TAPE].
1
Press [c OPEN] on both decks and insert the tapes.
2
For playback: Into deck 1
For recording: Into deck 2
Close the holders by hand.
Tape direction is automatically set to " 3".
Press [REV MODE] to select the reverse mode.
3
Every time you press the button:
: One side is recorded, then recording stops auto-
matically.
: Both sides (front side
,
then recording stops automatically.
Press [TAPE EDIT] to start recording.
4
•
If you selected "
automatically change to "
To stop recording:
Press [L].
Both decks will stop.
To start recording on the reverse side
Load a tape and change the tape direction as following.
1. Press [TAPE DECK 1/2] and select tape deck 2.
2. Press [/] and immediately thereafter [L]. The tape direction will
be shown as "4".
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
reverse side) are recorded,
" in step 3, the direction will
" when recording starts.
25
RQT4708