Electrolux ERCP3195AW Manual page 16

16 www.electrolux.com
Problem
Water flows on the floor.
Temperature cannot be set. The "Shopping function"
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
is switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "Shopping function"
is switched on.
There is no cold air circu-
lation in the appliance.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective
Solution
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.
Switch off "Shopping func-
tion" manually, or wait until
the function resets automati-
cally to set the temperature.
Refer to "Shopping function".
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Add less food products at the
same time.
Open the door only if neces-
sary.
Refer to "Shopping function".
Make sure that there is cold
air circulation in the appli-
ance.
assembly instructions.
door gaskets. Contact the Authorised
Service Centre.