Table of Contents
Advertisement
NOTE: There should be an "aver-
age" operating load on the snowmo-
bile when adjusting headlight aim.
2. Measure the distance from the floor
to midpoint of the headlight.
3. Using the measurement obtained in
step 2, make a horizontal mark on
the aiming surface.
4. Make a vertical mark which inter-
sects the horizontal mark on the aim-
ing surface directly in front of the
headlight.
5. Engage the brake lever lock and start
the engine. Move the headlight dim-
mer switch to the LOW beam posi-
tion. DO NOT USE HIGH BEAM.
6. Observe the LOW beam aim. Proper
aim is when the LOW beam is cen-
tered on the vertical mark 5 cm (2
in.) below the horizontal mark on
the aiming surface.
7. Adjust the headlight using the screw
on the backside of the headlight until
correct aim is obtained. Shut the
engine off; then disengage the brake
lever lock.
ONS-052R
0752-957
31
Advertisement
Table of Contents
