Step And Repeat Printing - Canon Arizona 6100 XTHF Mark II Series User Manual

Step and Repeat Printing

Step and Repeat Printing
Introduction
Step and Repeat Printing allows the operator to define a grid and place an image in each cell to
print multiple copies. The operator selects the number of rows and columns desired and the
number of copies needed and the copies of the image are positioned in each cell of the grid. If
there are not enough cells to hold the number of images the printer will wait for new media to be
placed and then continue the job. The next part of the job will begin on the topmost row of the
grid and print down until the set number of copies is achieved.
Step and Repeat printing is also possible on prints that are set up for the Roll Media Option. In
this case the grid is also shown in the Preview and is centered on the paper if there is enough
space on both sides of the grid. If there is not enough space for the size of grid and number of
copies, the job will continue further along the media and will start again at the position of the left
column. The job continues in this manner until the set number of copies has printed.
Step and Repeat Setup
Procedure
1. Select a print job from either the Active or Inactive job list.
2. Select Step and Repeat in the Print Job Parameters panel.
110 Chapter 6 - How to Print in Batch and Dual Origin Modes