Table of Contents
Advertisement
2.
Keylever Pawl to Interposer Clearance
a.
Adjust the keylever pawl guide so that the lower
edge is 9/16" from the bottom of the operational
bracket (Fig. 112).
Keylever Pawl Guide
FIGURE
112.
Interposer Height
b.
Position the keylever stop so that all keylevers clear
their interposer .020" to .030" (Fig. 113),
.020" to .030"
Interposer
FIGURE 113.
Keylever Pawl To Interposer Clearance
3.
Operational Latch Height - The adjustable latch screws
(Fig. 114) (eccentric stop on tab latch) for the back-
space, spacebar, and tab operational latches should be
adjusted so that the latches will pass under the cam fol-
lower lever with a clearance of .003" to .015" (Fig.
114B). The carrier return operational latch ad justable
stop should be adjusted so that the latch will pass under
the cam follower with .003" to .010" clearance (Fig.
115) .
NOTE:
Be sure that the cams are latched when this
clearance is observed. The high sicie of the specifica-
ti on is preferred.
NOTE:
The clearances may be observed by pulling the
latches to the rear with a spring hook whi Ie the machine
is at rest.
2-36
Bristo Head
Latch
003" - .015"
FI GURE 114A.
Tab Latch Height
Adjusting Screw
Spacebar or Backspace
Operati ona
J
Latch
FIGURE 114B.
Latch Height
Be
Sure Cam
Is Latched
p/
/""~
-~
E-
IQL " ' , , : : ' . :
"~
.003" to .015"
~
T
Adjusting Screw
\
~N
~
\ :.
Carri er Return
~)
('
Latch Assemb
I
y
r·/\
\
I
\
I
\, \~---i
~0111
to .010"
o
, .
I~\\)--r
Cam Follower Lever
FIGURE 115.
Latch Height (11 Inch.)
Advertisement
Chapters
Table of Contents
