Zenith H27F56DT Installation And Operating Manual page 49

Troubleshooting
Some quick and easy tips to resolving problems
Symptoms
Source Selection / Source Image Problems
Camport (front Audio/Video) • Equipment not connected.
source not selectable.
No Camport image.
(front Video)
S-Video Source not
selectable.
No S-Video Out.
No S-Video image.
No S-Video audio.
Antenna/Cable
not selectable.
No Antenna/Cable image.
Rear Audio/Video
not selectable.
No rear Audio/Video image.
206-3492-O
Possible Cause(s)
• Equipment not turned on.
• Camport (front Video)
connected.
• Not connected.
• S-Video output turned off
in Installer's Menu.
• Equipment not turned on.
• S-Video audio not connected.
• Front Video connected.
• S-Video equipment connected.
• Not connected.
• Front Video connected.
• S-Video equipment connected.
• Channel Override set to "0"
• Equipment not turned on.
• Equipment not connected.
Possible Solution(s)
-Connect Audio/Video equipment to front Audio/Video.
-Turn on equipment connected to front Video input.
-Disconnect equipment connected to front Video jack.
-Connect S-Video equipment to S-Video In.
-Enable Item 33-I, Y/C Looput in Installer's Menu. Refer to
Installer's menus.
-Turn on equipment connected to S-Video In.
-Connect audio for S-Video to Audio In R - L.
(Use Audio In L jack to connect one audio wire.)
-Disconnect equipment connected to front Video.
-Disconnect S-Video equipment from rear jackpack.
-Connect over-the-air antenna or cable service wire
to Antenna/Cable jack.
-Disconnect equipment from front Video jack.
-Disconnect S-Video equipment from rear jackpack.
-Access Installer menu and set Item 28-I CH OVERRIDE to "1".
Go to Setup menu, select Add/Del/Blank option. Press 9-9-9
to select AUX. Press MENU, select "Added" in Add/Del/Blnk
option in Setup menu. (See Installer menus.)
-Turn on equipment connected to rear Audio/Video.
-Connect equipment to rear Audio/Video.
See Page(s)
19/20
19/20
19/20
19/20
14/17
14/19/20
19/20
14/20
10/11
19/20
14/20
12 - 14
P A G E 4 9