Zenith H27F56DT Installation And Operating Manual page 12

Hook Up Over-The-Air Antenna and VCR
Connect your off-air antenna and VCR to the TV
1
Locate the Antenna/Cable (In) jack on the back of
the VCR.
2
Connect the wire that runs from the antenna direct-
ly to this jack, according to one of the connection
diagrams shown to the right.
3
Remove the back of the remote and put in two AA
batteries.
4
Plug in the TV. The TV is designed to operate on
standard current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC Current.
120 Volt
60 Hz AC
No A/V cables are included with the Zenith
TV.
Without A/V cables, most VCRs will not play
videocassettes in stereo sound.
P A G E 1 2
Back of
Remote
Antenna
Flat Wire
(300 ohm)
Typical
TV Back
Matrix Out
Component Video Input
Antenna
Pr Pb
Cable R Audio L
Y
Video In
R Audio In L
M.P.I.
S-Video Out S-Video In
R Audio In L
Antenna
RF Coaxial Wire
(75ohm)
Typical
TV Back
Matrix Out
Component Video Input
Antenna
Pr Pb
Cable R Audio L
Y
Video In
R Audio In L
M.P.I.
S-Video Out S-Video In
R Audio In L
VCR Back
VCR Back AV Panel
output
In
switch
3 4
Out
Audio
Video
300/75 ohm
Adapter
A/V cables
not included
with TV
VCR Back
VCR Back AV Panel
output
In
switch
3 4
Out
Audio
Video
A/V cables
not included
with TV
206-3686