Zenith H27F56DT Installation And Operating Manual page 10

Hook Up An Over-The-Air Antenna
Connect an off-air antenna
1
Locate the Antenna/Cable jack on the back of
the TV.
2
Connect the antenna that runs from the wall
directly to this jack, according to one of the
connection diagrams shown to the right.
3
Remove the back of the remote and put in two
AA batteries.
4
Plug in your TV. This TV is designed to operate
on standard current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC Current.
120 Volt
60 Hz AC
If you have a 75 ohm RF cable, then you don't
need any adapters!
A 300 to 75 ohm adapter is not included with the
Zenith TV.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack (Antenna/Cable). They are usually about an inch long
300 TO 75 OHM
with two screws on one end and a round opening with a wire sticking out on the other end.
ADAPTER
P A G E 1 0
Back of
Remote
Antenna
Flat Wire
(300 ohm)
300/75 ohm
Adapter
Antenna
RF Coaxial Wire
(75 ohm)
Typical
TV Back
Matrix Out
Component Video Input
Antenna
Pr
Pb
R Audio L
Cable
Y
Video In
R Audio In L
M.P.I.
S-Video Out S-Video In
R Audio In L
Typical
TV Back
Matrix Out
Component Video Input
Antenna
Pr Pb
R Audio L
Cable
Y
Video In
R Audio In L
M.P.I.
S-Video Out S-Video In
R Audio In L
206-3686