Table of Contents
Advertisement
Hook Up An Over-The-Air Antenna
Connect an off-air antenna to the
Presentation TV
1
Locate the Antenna/Cable jack on the back of
the Presentation TV.
2
Connect the cable that runs from the wall
directly to this jack, according to one of the
diagrams shown to the right.
3
Remove the back of the remote and put in two
AAA batteries.
back of
remote
4
Plug in your TV. Do not plug it into a switched
outlet. Your Entertainment Machine is designed
to operate on standard current, 120-volt 60
Hertz AC. Do not attempt to operate it on DC
Current.
5
Go to page 14 to Auto Program the
Presentation TV.
If you have a 75 ohm RF cable, then you
don't need any adapters!
A 300 to 75 ohm adapter is not included with
the Zenith Presentation TV.
Mini glossary
75 OHM RF CABLE
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack (Antenna/Cable). They are usually about an inch long
300 TO 75 OHM
with two screws on one end and a round opening with a wire sticking out on the other end.
ADAPTER
206-3678
Antenna
Flat Wire
(300 ohm)
300/75 ohm
Adapter
Antenna
RF Coaxial Wire
(75ohm)
TV Back
Antenna
Cable
Video
Matrix
In
Out
M.P.I.
S-Video
S-Video
In
Out
R- Audio - L
In
TV Back
Antenna
Cable
Video
Matrix
In
Out
M.P.I.
S-Video
S-Video
In
Out
R- Audio - L
In
P A G E 7
Advertisement
Table of Contents
