Table of Contents
Advertisement
Troubleshooting
Some quick and easy tips to resolving problems
Symptoms
Source Selection / Source Image Problems
Camport (front Audio/Video) • Equipment not connected.
source not selectable.
No Camport image.
(front Audio/Video)
S-Video Source not
selectable.
No S-Video image.
No S-Video audio.
Antenna/Cable
not selectable.
No Antenna/Cable image.
Rear Audio/Video
not selectable.
No rear Audio/Video image.
206-3678
Possible Cause(s)
• Equipment not turned on.
• Camport (front Audio/Video)
connected.
• Not connected.
• Equipment not turned on.
• S-Video audio not connected.
• Front Audio/Video connected.
• S-Video equipment connected.
• Not connected.
• Front Audio/Video connected.
• S-Video equipment connected.
• Deleted from channel scan.
• Channel Override set to "0"
• Equipment not turned on.
• Equipment not connected.
Possible Solution(s)
-Connect Audio/Video equipment to front Audio/Video.
-Turn on equipment connected to front Audio/Video.
-Disconnect equipment connected to front Audio/Video.
-Connect S-Video equipment to S-Video In.
-Turn on equipment connected to S-Video In.
-Connect audio for S-Video to rear Audio In R - L.
(Use Audio In L jack to connect one audio wire.)
-Disconnect equipment connected to front Audio/Video.
-Disconnect S-Video equipment from rear jackpack.
-Connect over-the-air antenna or cable service wire
to Antenna/Cable jack.
-Disconnect equipment from front Audio/Video.
-Disconnect S-Video equipment from rear jackpack.
-Press TV/VCR Source.
-Access Installer menu and set Item 19 CH OVERRIDE to "1".
Go to Setup menu, select Add/Del/Blank option. Press 9-9-9
to select AUX. Press MENU, select "Added" in Add/Del/Blnk
option in Setup menu.
-Turn on equipment connected to rear Audio/Video.
-Connect equipment to rear Audio/Video.
See Page(s)
15/17
15/17
11/17
11/17
15/17
11
7/8/17
15/17
11/17
16
37
9/10/17
P A G E 4 5
Advertisement
Table of Contents
