Zenith Concierge H27D35DT Installation & Operating Manual page 8

Hook Up Your Cable (CATV) to the TV
Connect cable service to the TV
1
Locate the Antenna/Cable jack on the back of the
TV.
2
Connect the wire that runs from the wall directly
to this jack, according to one of the diagrams to
the right.
3
Remove the back of the remote and put in two AA
batteries.
4
Plug in the TV. Do not plug it into a switched
outlet. The TV is designed to operate on normal
current, 120-volt 60 Hertz AC. Do not attempt to
operate it on DC power.
120 V AC
60 Hz
5
Go to page 12 to Auto Program the TV.
If you're using a cable box, leave the TV on channel 3
or 4 and use your cable box to change channels.
If you're using a cable box, Auto Program might only
find the channel your cable service is on (usually chan-
nel 3 or 4). Don't worry, that's all you need!
P A G E 8
Back of
Remote
Cable TV
Wall Jack
RF Coaxial Wire
(75ohm)
Cable TV
Wall Jack
Cable Box
In
output
Out
switch
3 4
RF Coaxial Wire
(75ohm)
TV Back
MATRIX
VIDEO
IN OUT
M.P.I.
R- AUDIO- L
IN
TV Back
MATRIX
VIDEO
IN OUT
M.P.I.
R- AUDIO- L
IN
206-3489-O