Hook Up Cable Service (Catv) And Vcr - Zenith Concierge H27D35DT Installation & Operating Manual

Hook Up Cable Service (CATV) and VCR

Connect a VCR and Cable service to the TV
1
Locate the Antenna/Cable In jack on the back of
the VCR.
2
Connect the wire that runs from the wall, accord-
ing to one of the diagrams to the right. As
required, make the other connections as shown to
the right.
3
Remove the back of the remote, put in two AA
batteries.
4
Plug in the TV. Do not plug it into a switched
outlet. The TV is designed to operate on standard
current, 120-volt 60 Hertz AC. Do not attempt to
operate it on DC power.
120 V AC
60 Hz
5
Go to page 12 to Auto Program the TV.
Leave the VCR and the television tuned to channel three
and use the cable box to change channels.
No A/V cables are included with your TV. Without A/V
cables, most VCRs will not play videocassettes in stereo
sound.
P A G E 1 0
Back of
Remote
Round Wire (75ohm)
TV Back
VIDEO MATRIX
IN OUT
M.P.I.
R- AUDIO- L
IN
TV Back
Connections Panel
(Expanded View)
Cable TV
Wall Jack
In
Out
TV Back
VIDEO MATRIX
OUT
IN
M.P.I.
R- AUDIO- L
IN
TV Back
Connections Panel
(Expanded View)
Cable TV
Wall Jack
VCR Back
VCR Back AV Panel
output
In
switch
R - L
Out
Audio Video
A/V cables
not included
with TV
VCR Back
Cable Box
output
switch 3 4
VCR Back AV Panel
Round Wire (75ohm)
output
In
switch
R - L
Out
Audio Video
A/V cables
not included
with TV
3 4
3 4
206-3489-O