Auto Program - Zenith Concierge H27D35DT Installation & Operating Manual

Auto Program (Channel Search)
Use Auto Program to specify Antenna or cable service
incoming signal source and automatically store all of the
channels that are found by channel search
1
With the Installer remote control in hand, press the
POWER key to turn on the TV.
2
Press MENU repeatedly until the Setup menu appears.
3
Using SELECT on the remote control, highlight Auto
Program on the screen.
4
Press the Right or Left ADJ (Adjust) arrow to go to the
Auto Program screen.
5
Using SELECT, choose either Cable TV or Off-Air Antenna
on your screen. (The flashing option is selected.)
6
Press the Right or Left ADJ arrow to begin the Channel
Search.
7
Press ENTER when finished.
Auto Program finds channels being received by the TV tuner.
Cable will not work unless a cable service is present.
Mini glossary
OFF-AIR-ANTENNA If the guest can only view over-the-air broadcasts, select Antenna.
CABLE If you provide cable service to your guests, select Cable.
P A G E 1 2
1
1 2
4 5
7 8
0
TIMER
MENU
SELECT
3/5
ADJ
4/6
3
6
9
ENTER
7
2
ALARM
CH PREVIEW
ADJ
206-3489-O