Cable Service With Vcr - Zenith Concierge H20D35DT Installation And Operating Manual, Warranty

Cable Service (CATV) With VCR Hook Up
Connect a VCR and Cable service to the TV
1
Locate the Antenna/Cable jack on the back
of the VCR.
2
Connect the cable service wire, according to
one of the diagrams to the right. As
required, make the other connections as
shown to the right.
3
Remove the back of the remote, put in two
AA batteries.
4
Plug in the TV. Do not plug it into a
switched outlet. The TV is designed to oper-
ate on standard current, 120-volt 60 Hertz
AC. Do not attempt to operate it on DC
power.
5
Go to page 12 to Auto Program the TV.
Leave the VCR and the television tuned to channel
three and use the cable box to change channels.
No A/V cables are included with your TV. Without
A/V cables, most VCRs will not play videocassettes
in stereo sound.
P A G E 1 0
back of
remote
TV Back
MATRIX
VIDEO
OUT
IN
M.P.I.
R- AUDIO- L
IN
TV Back Connections Panel
(Expanded View)
Cable TV
Wall Jack
In
Out
TV Back
VIDEO MATRIX
OUT
IN
M.P.I.
R- AUDIO- L
IN
TV Back Connections Panel
(Expanded View)
Cable TV
Wall Jack
VCR Back AV Panel
Round Wire (75ohm)
In
Out
A/V cables
not included
with TV
Cable Box
output
switch 3 4
VCR Back AV Panel
In
Round Wire (75ohm) Out
A/V cables
not included
with TV
VCR Back
output
switch
3 4
R - L
Audio Video
VCR Back
output
switch
3 4
R - L
Audio Video
206-3489-O