Troubleshooting / Fault Codes - Scheppach ROBOCUT XXL900 Operating And Safety Instructions Manual

15. Troubleshooting / fault codes

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
15.1 Fault table
Fault
Mower does not start
LED light on charging station
does not light up
LED light on charging station
flashes red
Mower does not mow properly Blades are worn
Mower starts at unusual/
wrong times
Mower gets stuck
15.2 Fault codes
Error code Meaning
---- Rain sensor delay
Mower outside the
E1
working area
Wheel motor
E2
blocked
E3 Cutter disc blocked
Obstacle
E4 sensor trigger not
reset
The mower was
E5
lifted
Roll-over sensor
E6
was triggered
Possible cause
Mower or charging station not con-
nected to the mains
Boundary wire is not connected or
cut/broken.
Date/time is incorrectly set
Unsuitable terrain/obstacle
Remedy
• -
1. Check that the mower is in the working area.
2. Ensure that the charging station is properly connected to the battery charger and
charger is connected to a suitable power supply.
3. Make sure that the boundary wires have been clamped correctly and replace
them if necessary.
1. Switch the mower off. Move the mower to an area that is free of obstacles. Press
the "START" button and then the "OK" button.
2. If the error message is still displayed, switch off the product. Turn the mower up-
side down and check what is preventing the wheels from turning.
3. Remove the objects blocking the wheel(s), turn the mower over.
4. Press the "START" button and then the "OK" button.
1. Switch the mower off.
2. Turn the mower upside down and check what is preventing the blades from turn-
ing.
3. Remove the objects and turn the mower over.
4. Place the mower in an area with short grass.
5. Press the "START" button and then the "OK" button.
1. If the error still occurs, contact your specialist dealer.
1. Switch the mower off.
2. Move the mower to an area that is free of obstacles. Press the "START" button
and then the "OK" button.
3. If the error message is still displayed, switch off the product. Turn the mower up-
side down and check if there is anything preventing the front axle from moving.
4. Remove all obstacles, turn the mower over and switch it on. Press the "START"
button and then the "OK" button.
1. Position the mower.
2. Press the "START" button and then the "OK" button.
www.scheppach.com
Remedy
• Connect the power supply unit to a suitable
power source
• Call a specialist if necessary
• Connect/repair boundary wire
• Replace blades
• Set the correct date and time
• Adapt the terrain/obstacle to the requirements
of the robot mower
• Adjust the laying of the boundary wire accord-
ingly
GB | 35