A
Hook Up Your Antenna and VCR
Connect a VCR to your Entertainment Machine.
Locate the Antenna/Cable jack on
1
the back of your Entertainment
Machine.
Connect the cable that runs from
2
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
3
and put in two AAA batteries.
back of
remote
Plug in your Entertainment
4
Machine. Do not plug it into a
switched outlet. Your
Entertainment Machine is
designed to operate on house-
hold current, 120-volt 60 Hertz
AC do not attempt to operate it
on DC Current.
Go to page 10 to Auto Program
5
your Entertainment Machine.
If you have a 75 ohm RF cable,
then you don't need any adapters!
Remember, when screwing RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
Note: You will need to connect a VCR to
your television in order to use the
Picture-In-Picture feature. (See page 29
to set the signal source for your PIP)
P A G E 8
Antenna
Flat Wire Antenna with VCR
Flat wire
(300 ohm)
TV back
RF coaxial wire
TV back panel
(expanded view)
Audio In Video
Antenna
Cable
Antenna
Antenna with VCR
RF coaxial wire
(75 ohm)
TV back
RF coaxial wire
TV back panel
(expanded view)
Audio In Video
Antenna
Cable
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Video
Audio
(75 ohm)
not included
with TV
A/V cables
not included
with TV
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Video
Audio
(75 ohm)
not included
with TV
A/V cables
not included
with TV
206-3480