CONTROL
BOARD
FUSE
REPLACEMENT
(200 SERIES)
The control board fuse is located on the control board (See Figure 2).
Disconnect power from Unit before servicing.
1.
Open
rear access
panel of Warming
Unit by removing
the four Phillips head
screws.
Remove
the filter.
Remove the lower filter seat angle (See Figure 3) by removing the three T25 black
torx Screws.
Identify the control board (See Figure 3).
Locate the fuse (See Figure 2) and replace as specified.
Reverse steps 1-3.
ТРЗ
ТРА
CONTROL- T 7
BOARD
FUSE
Figure 2.
Control Board Fuse
(200 Series)