Table of Contents
Advertisement
(9)
Serial Port COM2
COM2 is the 9-pin D-Subminiature male connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED PERIPHERALS
SETUP" section for more detail information.
(10) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
(11) Ultra ATA100 IDE Connector (40-pin block): IDE1 (Support ATA 100)
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If
you install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
SPDIF Out
PS/2
Mouse
PRINTER
PS/2
Keyboard
SPDIF In
FDD
Floppy Drive Connector
IDE1
Pin 1
Ultra ATA100 IDE Conn.
24
RJ45 LAN
USB1
UL1
COM2
Pin 1
Line-IN
Surrback
CEN/LFE
Line-OUT
Surround
MIC-IN
Advertisement
Table of Contents
