Additional Safety Instructions For Sanding - Energizer EZ900AG User Manual

c) When wheel is binding or when interrupting a cut for any reason, switch off the power
tool and hold the power tool motionless until the wheel comes to a complete stop. Never
attempt to remove the cut-off wheel from the cut while the whee丨 is in motion otherwise
kickback may occur. Investigate and take corrective action to eliminate the cause of wheel
binding
d) Do not restart the cutting operation in the workpiece. Let the wheel reach full speed and
carefully re-enter the cut. The wheel may bind, walk up or kickback if the power tool is
restarted in the workpiece
e) Support panels or any oversized workpiece to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under their own weight.Supports must be placed
under the workpiece near the line of cut and near the edge of the workpiece on both sides
of the wheel
f) Use extra caution when making a "pocket cut'* into existing walls or other blind areas.The
protruding wheel may cut gas or water pipes, electrical wiring or objects that can cause
kickback.

12. ADDITIONAL SAFETY INSTRUCTIONS FOR SANDING

OPERATIONS
Safety Warnings Speci c for Sanding Operations
a) Do not use excessively oversized sanding disc paper. Follow manufacturer's recommen-
dations, when selecting sanding paper. Larger sanding paper extending beyond the
sanding pad presents a laceration hazard and may cause snagging, tearing of the disc or
kickback
Additional safety rules for angle grinders
• DANGER OF ELECTRIC SHOCK! Do not operate the device if the mains lead
or mains plug is damaged.
• DANGER OF ELECTRIC SHOCK! Do not touch the mains lead if it becomes damaged or
cut through while you are using the device. Pull the plug out of the mains socket immedia-
tely and have the device repaired by a suitably quali ed person or at your service centre.
• DANGER OF ELECTRIC SHOCK! Do not operate the device if it is damp and do not use it
in a damp environment.
• DANGER OF ELECTRIC SHOCK! If you use the device outdoors, always connect it
through a residual current device with a maximum trip current of 30 mA. If using an
extension lead, always use one that is approved for outdoor use.
Do not suspend or carry the device by the mains lead. Always work with the mains lead
leading away from the rear of the device. Otherwise the device could be damaged
• Grinding discs must be carefully kept and handled in accordance with the manufacturer's
instructions. Otherwise they could be damaged.
• Make sure that abrasive consumables and tools are attached in accordance with the
manufacturer's instructions and advice. Otherwise they could become detached from the
device and result in injury and / or damage to property.
Ensure that any spacers supplied and required for the use of certain abrasive consumables
and tools are installed
• Do not use separate reducing bushes or adapters in order to make grinding discs with a
larger bore t.
When using abrasive consumables and tools with a threaded insert make sure that the
tread is long enough for the spindle length. Otherwise the grinding discs could become
detached from the device and result in injury and / or damage to property
13