Afterglow F210004-B2 Manual page 6

5. Attach back panel (C) to back-left leg (G) and back-right leg (H) with bolts (AA) and washer (CC) using hex screw
driver (DD), (see Figure 5).
NOTE: DO NOT tighten the screws completely.
Hardware Used:
AA Bolts (M6 x 12)
CC Washer (M6)
DD Hex screw driver
6. Attach gas cylinder support (K) to back-left leg (G) and back-right leg (H) and front-left leg (J) and front-right leg (I)
with bolts (BB) and washer (CC) using hex screw driver (DD), (see Figure 6).
NOTE: Tighten all screws completely.
Hardware Used:
BB Bolts (M6 x 15)
CC Washer (M6)
DD Hex screw driver
7. With the help of another person, carefully turn the fire pit to the upright position. Attach the door panel (E) to the
front right leg (I) by aligning the hinge on the door panel with those on the front right leg (I) and inserting the pins in
the hinges, (see Figure 7).
8. Attach the door handle (N) to the door panel (E) with the bolt (EE) using a Phillips screwdriver (NOT included),
(see Figure 8).
Hardware Used:
EE Bolt (M4 x 10)
x 4
x 4
x 1
x 4
x 4
x 1
x 1
N
DD
C
G
AA
CC
H
J
K
G
H
I
E
E
Figure 5
CC
BB
DD
I
Figure 6
Figure 7
Figure 8
06