Lighting Instructions; To Turn Off Gas - Afterglow F210004-B2 Manual

1. Push in gas control knob slightly and turn to "OFF".
2. Turn gas control knob to "ON/MIN".
3. Push in gas control knob all the way and hold. Continue to press the ignition button for 15 seconds.
4. If the burner does not light in 15 seconds, release the knob and it will pop back out. Wait 5 minutes before
attempting to light the burner again and repeat step 1 to 3.
1. Push in gas control knob slightly and turn to "OFF".
WARNING: For your safety, read and follow the Lighting Instructions in this manual and in the Rating Plate on the
appliance. IMPROPER LIGHTING PROCEDURES COULD RESULT IN A FIRE HAZARD OR EXPLOSION
HAZARD OR PROPERTY DAMAGE, INJURY OR LOSS OF LIFE.
OFF
(APG.)
ON/MIN
(ENC./MÍN.)
Observe Flame Height When Lit: The burner will display blue and yellow flames. These flames should be a blue /
yellow color between 1~2 in. height, (see Figure 18). These flames should not be yellow or produce thick smoke.
This would indicate an obstruction of airflow through the burners. The flames should be blue with straight yellow tops.

LIGHTING INSTRUCTIONS

TO TURN OFF GAS

MAX
(MÁX.)
gas control knob
Good
Light Blue
ignition button
Bad
Yellow
Blue
Figure 18
IGNITOR
(Encendedor)
1 AAA
1.5V
Figure 17
Yellow
Light Blue
Blue
10