Shark Detect Pro IW3000 Series Owner's Manual page 32

USING YOUR VACUUM
ABOVE-FLOOR WITH HAND VACUUM
Detach the hand vacuum to clean above-
floor areas. Press the front latch release
button on the hand vac where it meets the
wand, then lift off the hand vacuum. To
attach an accessory to the hand vacuum,
slide it into the opening in the nozzle. To
remove, press the front latch release button
on the hand vac where it meets the wand,
and slide out the accessory.
NOTE: All accessories are compatible with both the wand and the hand vacuum.
62
s h a r kc l e a n . e u
ABOVE-FLOOR WITH WAND
To detach the floor nozzle from the wand,
step on the nozzle while pressing the
nozzle release button at the bottom of
the wand. Lift the wand to remove it. To
reattach the wand, align it over the neck
of the floor nozzle, then slide it on until it
clicks into place.
USING YOUR VACUUM
USING THE AUTO-EMPTY DOCK (IW3000 SERIES)
Place the vacuum on the dock in a downward
motion. Once properly attached, the
auto evacuation process will begin. The
evacuation cycle will last for 15 seconds.
QUIET MODE BUTTON LOCATION
Press the button on the top of the dock that
shows an image of a moon. This will initiate
Quiet Mode. When the dock is in Quiet Mode,
you can dock the vacuum without auto
evacuation occurring.
Note: do not remove the vacuum while the evacuation cycle is taking place.
Once evacuation is complete, the vacuum
will continue charging until it is removed
from the dock.
DUST BIN FULL INDICATOR
The Dust Bin Full indicator will illuminate
when the dust bin is full of debris and needs
to be emptied. To reset the indicator, remove
the dust bin and empty it.
s h a r kc l e a n . e u
63