Advertisement
Available languages
Available languages
PREAMP OUT (24)
The preamp output can be used to route the amplified signal to a mixing console, tape recorder, etc. Connect
the preamp output using a shielded cable to an input of the tape recorder, mixer, etc. This patch does not
affect the operation of the amplifier.
EFFECTS RETURN (25)
Input for returning signals from external low-level effects or signal processing equipment
EFFECTS SEND (26)
Output for supplying signals to external low-level effects or signal processing equipment.
GROUND SWITCH (27)
Three position roeker-type switch which, in most applications, should be operated in its center or zero posi¬
tion. There may be some situations when audible hum and/or noise will come from the loudspeaker. If this
situation arises, position the ground switch to either positive or negative (-^ or -) or until the noise is minimized.
NOTE: Should the noise problem continue, consult your Authorized Peavey Dealer, the Peavey Factory or
MODELS
technician. THE GROUND SWITCH IS NOT FUNCTIONAL ON 220/240 VOLT
LINE CORD (120V PRODUCTS ONLY) (28)
For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities. It is not
advisable to remove the ground pm under any circumstances. If it is necessary to use the equipment without
proper grounding facilities, suitable grounding adaptors should be used. Less noise and greatly reduced shock
hazard exists when the unit is operated with the proper grounded receptacles
Advertisement
