Advertisement
Available languages
Available languages
ENGLISH
POWER SWITCH (1)
Depress the switch to the "On" position. The red pilot light (LED) will illuminate indicating power is being
supplied to the unit.
STANDBY SWITCH (2)
Allows amp to be placed in standby or active mode. In standby mode the tubes remain hot, but the amplifier
is not operational.
POWER LED (3)
Illuminates when AC power is being supplied to the amp.
STATUS LED (4)
Illuminates when amp is switched to standby indicating amplifier is not operational.
MASTER LEVEL (5)
Controls the overall volume level of the system. Once a desired balance of the Clean, Crunch, and Ultra chan¬
nels is achieved, the entire system level may be increased or decreased with the Master Level Control.
REVERB LEVEL (6)
Reverberation is an echo effect. Rotate clockwise to increase the effect. Remote footswitch can control On/Off.
EDGE (7)
An active tone control (shelving type, ±15 dB) that varies the high frequency boost or cut.
NOTE:
This control is not functional on the Clean channel.
BODY (8)
An active tone control (peak/notch, ±15dB) that varies the mid frequency boost or cut.
NOTE:
This control is not fuctional on the Clean channel.
BOTTOM (9)
An active tone control (shelving type ±15 dB) that varies the low frequency boost or cut.
NOTE:
This control is not functional on the Clean channel.
POST GAIN (10)
Controls the overall volume level of the channel. The final level adjustment should be made after the desired
sound has been achieved.
PRE GAIN (11)
Controls the input volume level of the channel.
CRUNCH GAIN SWITCH (12)
Boosts the overall system gain of the crunch channel. Depress to the "in" position to activate.
Advertisement
