Connecting Speakers; Connecting The Mains; Detaching The Side Panels; Inserting The Batteries - Sony TA-S2 Operating Instructions Manual

of
> continued
Connecting Speakers
Speaker
to speaker to speaker
terminal terminal
SPEAKERS R SPEAKERS L
| - BGO
apes
© D
OOO ojo G =
eslecioa) |O N e
Amplifier (TA-S2)
Chapter 1: Connecting the System
Connecting the Mains
Turn on the components except for TA-S2
after connecting the mains.
The power will turn on/off automatically
when the nower of the TA-S? firns on /off
wren uwie power Gre 1A-oe cuirns O7/ O11.
Connect to the
mains last.
Amplifier (TA-S2)
Tuner
Cassette deck (TC-S1)
Detaching the Side Panels
If you choose to remove the side panels
from the unit, do not reinsert the side panel
screws into the cabinet holes. Use the
shorter M3 x 6 screws (supplied) instead.
For safety's sake, disconnect the AC power
cord from the AC outiet before inserting the
M3 x 6 screws into the cabinet holes.
ee IT NG DS era
Inserting the
Batteries
Insert two size AA (R6) batteries into the
supplied remote commander for remote
control.
1 Slide the lid to remove it.
2 insert two size AA (R6) batteries.
Match the + and - to the diagram in the
battery compartment.
3 Slide the lid to replace it.
Battery life
You can expect the remote commander to
operate for about six months (using Sony
SUM-3 (NS) batteries) before the batteries run
down. When the batteries have run down so
the commander no longer works properly,
replace both the batteries with new ones.
To avoid battery leakage
If you are not going to use the commander for
a Jong time, remove the batteries to avoid
damage caused by corrosion from battery
Jeakage.