Respekta CH 99060 S A Installation Instructions Manual page 9

Mounting the hood for exhaust air operation:
Attention! Be sure to observe chapter 11. "Installation" of user's manual.
The wall duct must be dimensioned for a 150 mm exhaust hose. (Drill hole about
155mm).
To mount the hood in exhaust air mode, mount it as described in the above chapter:
"Mounting the hood for recirculation mode:" , but without mounting the carbon
filters.
Proceed as follows during assembly:
1. Remove the outer and inner chimney.
2. Mount the exhaust hose. (Fig. k)
3. Replace the outer and inner chimney.
(a)
Illustrations serve partially just for illustration
fi200507ATL
For the final assembly of the hood in exhaust air
operation, you need an exhaust grille with a 150mm
socket (a) for the connection of the exhaust air hose.
This is not included in the delivery.
4 / 4 Figures are partially for Illustration only
Fig. k)