Table of Contents
Advertisement
-
-
-
78
Before you begin this procedure, make sure you have a copy of
Form F. You will use the form later in the procedure.
The following devices must be prepared for system checkout:
•
If you have an IBM 4214 Model 2, 5219, 5224, 5225,
5256, or 5262 Model 1 Printer, go to
DJ
for
instructions on how to prepare the printer(s) for system
checkout.
•
If you have an IBM Personal Computer, make sure:
The Display Station Emulation Adapter or Enhanced
Display Station Emulation Adapter is installed.
The 5250 Emulation Program or Enhanced 5250
Emulation Program is loaded and online.
For instructions. see Appendix A
.
Make sure of the following:
•
All Power switches on all devices in your system are set to
the
I
(On) position.
•
•
•
•
The Power Unit Emergency switch on your computer is set
to the Power Enable position.
The checkout diskette is still in the computer. ------
The security key on your computer is in the Service
position.
----
The security key on each display station is turned to the
On position (see the setup manual for that device).
The 3262 Printer does not have to be readied at
this time
.
----------Note: If you are attaching an 8809 Tape Drive
to a computer that is set up already, use the
checkout diskette you received from PIO
(Program Information
Department).
Always use
the latest level checkout
diskette.
Display stations will not have the security key
unless the Keylock feature was
ordered.
Advertisement
Table of Contents
