Basic Functions - Akai Party Box 810 User Manual

TRANSPORTATION
For transportation, use the upper handle, slightly fold the appliance and use the two rear wheels.
POWER
This unit works with 8V/7A lead acid rechargeable battery and 100-240V power supply.
When the battery is being phased out and the device does not turn on, plug the power cord into the
Power socket (15) on the device and plug into a wall socket to recharge.
Lamp status LED charging:
- Red LED indicator: The device is charging.
- Green LED indicator: The battery is charged.
Caution:
- Do not connect the appliance to sockets with a voltage other than indicated one.

BASIC FUNCTIONS

POWER ON/OFF
Long press the main ON/OFF power switch (01) to position ON to turn the power.
BATTERY CHARGE
- Connect the charging cable to the charging plug (15) the charging function and the LED
indicating charging status will start immediately.
For a longer battery life it is recommended to disconnect the main power cable after 10 hours max
of recharging.
If the battery is empty, please turn the speaker off and recharge for at least half an hour
before using it again.
STAND-BY
You can switch the system to standby mode using the button (01) on remote control:
Press it again to Switch On the unit. Caution:
- In standby mode the battery is NOT recharged and the device has a minimum battery
consumption.
- When connecting the main power supply, long-press the power button (01) for 3 seconds,
the device will display turned
on. Which means it works normally. Short press the power button (01), the device will display
entering into stand-by mode. At the same time, the power button shows red light.
- For long periods of inactivity, it is necessary to disconnect the mains cable and recharge
the battery periodically.
PLAYBACK MODE SELECTION FUNCTION
To change the mode function, press the key (02) on the unit or press button (04) on
remote control to select: BLUETOOTH (the display BLUE), USB/SD (only if the USB socket (14)/
Micro SD (13) is connected to a memory, the display shows for a few seconds "USB" or "SD"),
AUX-IN (the display shows "LINE" or "FM").
ADJUSTING THE VOLUME
1. Turn the Main Volume control (09) to increase or decrease the overall volume of playback, or
use the buttons (05) and (11) on the remote control;
2. Press the button (07) and turn the knob (09) (treble / bass / microphone vol / microphone
echo / guitar vol) adjustment
PRE-EQUALIZER
This unit has a pre-set audio equalization system. Press the unit or the EQ button (10) on the
remote control repeatedly to select one of the 5 audio equalizations available and which best suits
the current sound reproduction.
SETTING TONE TREBLE AND BASS
Press the MENU (07) key (1) time to adjust the treble and (2) times to adjust the bass.