Voice Recording; Troubleshooting - Akai Party Box 810 User Manual

VOICE RECORDING

This unit capable of recording the voice on the USB memory or SD card when using the microphone.
is
The device will automatically create a folder called "Record" inside the USB memory and it will store all
log files.
1. Switch On the unit;
2. Insert a USB memory or a SD Card into the socket;
3. Select the USB or SD function
remote control;
4. Via the REC (06) button on the unit or REC button (03) on remote control to start recording,
the display will show "REC" and the time signature will start;
5. Press again REC button to stop recording. The unit will play, automatically, the recorded file.
Note:
- You can record only the voice.
- When the "Recording" function is activated, some appliance controls are dezactivated, they will
resume their normal function when the recording is stopped.

TROUBLESHOOTING

If a problem occurs, follow the steps in the table below.
If the problem still can't be solved, please contact your retailer.
Problem
No sound when power is turned
ON
Distorted sound
No sound from the microphone
No sound comes after inserting
USB/SD Card
Charging indication-red
flashing when there is low charge
Unable to charge or the battery
works only for short duration
If Speaker makes loud noises
MODE button (02) on the unit, or the
Possible cause
1.No input sound source comes
2.Volume knob in the lowest position
3.Voice switch off
4.USB/SD card not plugged
1.Volume is too loud
2. Audio file error
1.Microphone socket may not be plugged
properly.
2. Microphone switch may not be on.
3. Microphone volume is on lowest mode.
1. Incorrect file format
2. USB/SD may not be plugged properly
light Charging adapter is not inserted properly.
1. Connect with power cord to charge
2. Battery not fully charged
3. Battery life may have ended
1.Microphone switched on but may too
close to the speaker
2. Microphone switched on but is not
being used
3. Microphone volume may be too loud
4. Mobile phone is being used too close to
the speaker
5.Other wireless
placed very close to the speaker
1. Input AUX signal
2.Adjust volume
3. Turn on voice switch
4. Plug USB/SD card, play MP3
1. Turn the volume down
2. Check and change the audio file
1. Ensure
2. Turn on the microphone
3.Adjust the microphone volume as per
1. File format should be MP3
2. Plug USB/SD card correctly
1. Check if power cord connected properly
2. Extend charging time; normally it takes 6-
3. Replace old batteries with the same
1.Keep the microphone 2 meters away from
2.Turn off microphone if not in use.
3.Adjust microphone volume to lower mode
4.Keep mobile away from the speaker whilst
5.Keep the speaker away from other wireless
equipment may be
button (04) on the
Solution
the microphone
plugged into the socket.
users wish
It will not affect the speaker system. The
light is only used for indicating whether the
unit is charging
8 hour to fully charge
specification as the old batteries.
the speaker
a ending a call.
equipment
is correctly