Advertisement
installation with the rubber bush
(Fig. 9)
Installation without the rubber
bush (Fig. 10)
1. Dashboard
2. Holder
After inserting the holder into the dashboard,
select the appropriate tabs according to the
thickness of the dashboard material and bend
them inwards to secure the holder in place.
3. Rubber bush
4. Screw
5. Ground wire (black)
6. Nut (6 mm)
7. Drill a 5.5 — 6.0 mm diameter hole.
8. Screw (5 x 16 mm)
9. Scrap
Be sure to use the strap to secure the back of
the unit in place. The strap can be bend by hand
to the desired angle.
Fig. 9
Fig. 10
17
Advertisement
