Advertisement
Playing Compact Discs
Precautions When Using the Multi-Play CD
Control
* This model can be used as controller
when an optionally available multi-play
CD player (e.g., CDX-M30) is included in
the system. Programmed play does not
operate when used with the multi-CD
player CDX-M70 or CDX-M100.
See pages 11 through 14 for details on
operation procedures.
The Owner's Manual for the multi-play
CD player does not contain an explana-
tion of the CD controls for this unit. Read
this Owner's Manual for details on proper
operation and keep it handy for later ref-
erence.
Immediately after the multi-play CD play-
er is connected to the system, it may not
operate properly. In this case, press the
clear button of the main unit and the clear
button of the multi-play CD player, and at-
tempt operation again.
The Magazine Type Multi-Play CD play-
ers with GQ
mark and the
Mazazines with the same mark are
compatible for 5-inch (12 cm) discs.
Listening to the Compact Disc
Parts Identification
(Fig. 1)
[4] Disc Number search
[6] Program Clear
{7] Track Number Search/Fast Forward,
Reverse
[12] Source Selector
[15] ITP (Instant Track Program)
[16] Highlight Scan
{17] Mode
(19] Display
(Fig. 4)
[35] Disc
[36] Music Repeat/Disc Repeat
{37] Highlight Scan
[38] Random Play
[39] Track Number
[40] Disc Number
KEH-IVi5550
The unit incorporates priority cassette tape
play. The unit will not switch to multi-play
CD player while a tape is inserted, so be
sure to eject the tape when you wish to lis-
ten to CD play.
1.Press button [12] to change the display to
the Multi-Play CD player mode and to be-
gin disc play.
Each press of button [12] changes the mode
aoe
Multi-Play CD player — tuner —
OFF
2.Use the Disc Number Search function to
select a disc.
Select the desired disc by pressing one of
disc selected appears at position [40] on the
display.
Display [35] indicates whether the maga-
zine is loaded or empty.
¢ If the number at position [40] on the dis-
play does not change when you press a
button in Bank [4], it means that there is
no disc loaded in that tray.
3.Use Track Number search to select a
track.
Confirm that Track Number is shown at
Position [39] on the display. If not, press the
(+) and (-) sides of button [7] at the same
time. Press the (+) side of button [7] to in-
crease the number at Position [39], or the
(-) side to decrease the number. Holding ei-
ther side of button [7] down changes the
track number at high speed.
4.Adjust volume and tone (see page 6).
5.To stop disc play, press button [12].
At another press, the normal play resumes
from about where it stopped.
If you stopped operating a Multi-Play CD
Player CDX-M100 in the middle of music
and then restarted, the player resumes
playing from the very beginning of the se-
lection with which you stopped.
Note:
+ After you press a button in Bank [4], it
may take some time before play begins
due to the time necessary to load and set
the disc in the mechanism.
11
Advertisement
