Table of Contents
Advertisement
1
UNIT INsTallaTIoN
1.1
INsTallaTIoN WarNINGs
operators who install and service the appliance must wear the personal protective equipment
required by applicable law.
Installation must be carried out according to regulation standards, current legislation and in compliance with local technical
regulations and the required technical procedures.
The place of installation of the appliance and relative Alpha accessories must have suitable features (technical and structural),
such as to allow for (always in safe, efficient and comfortable conditions):
- installation (according to the provisions of technical legislation and technical regulations);
- maintenance operations (including scheduled, periodic, routine and special maintenance);
- removal (to outdoors in the place for loading and transporting the appliances and components) as well as the eventual
replacement of those with appliances and/or equivalent components.
The wall surface must be smooth, without any protrusions or recesses enabling access to the rear part. They are not designed to
be installed on plinths or floors (Fig. 1).
By varying the type of installation the classification of the appliance and precisely:
- Type b
or b
23
53
has been installed.
- Type c appliance if installed using concentric pipes or other types of pipes envisioned for the sealed chamber appliance for
intake of air and expulsion of flue gas.
The equipment classification is shown in the illustrations of the various installation solutions on the following pages.
Only professionally enabled companies are authorised to install Alpha gas appliances.
6
appliance if installed using the relevant terminals for air intake directly from the room in which the appliance
Advertisement
Table of Contents
