Advertisement
How to assemble
1.
Lay the center pipe sideways and remove the nut.
2.
Align the front base hook with the groove of the center pipe.
3.
Then assemble the base in the direction of the arrow.
4.
Finally, lock and screw the nut from the bottom of the base, and place the
assembled body upright to assemble the blade.
Nut
Reminder: Tight the nut securely, not to be loosened.
Please follow the step order and install
correctly before use
Remove the spinner, cap and guard
stopper nut
Please keep the plastic cap for storage use.
Fix the rear guard to the motor and
then tighten the guard stopper nut
securely
Align each of 3 holes and 3 projections, then fix the
rear guard to the motor, tight the guard stopper nut
securely (clockwise direction), (marks the arrowhead
of the rear guard points up).
Installing the blade
Insert the blade into the motor shaft closely,
then tighten with spinner securely.
(anti-clockwise direction)
Installing the front guard
Align the clips of the front guard with the
"matching mark" on the rear guard.
Engage the clip to fix the front and rear guard.
Engage the clip press backward and upward.
This product belongs to double insulation,
please assemble the clip properly to ensure
your safety.
Reminder:
Tighten every part securely to avoid the blade from coming out during the operation.
This product belongs to double insulation. Please assemble the guard properly to ensure your
safety. Make sure the clip pressed in before start the operation.
7
I n s t a l l i ng t h e st a nd
Bass hook
Center pipe
groove
I n s t al l i ng t h e b l ad e
3 projections
Blade
Matching
mark
Motor shaft
Guard stopper nut
Cap
Spinner
Spinner
Clip
Align the "matching
Make sure the clip
mark" with the front
presses backward
guard.
and upward
Guard
stopper
nut
Advertisement
