Table of Contents
Advertisement
At first, determine which CDC-805 is to be used as the main unit (or the second one). Connections should be made as
shown in the following figure.
Main unit
Set to the "MAIN"
side
Remote
control -
cable (included)
——- To amplifier
2nd
unit
Set to the "2nd":
side.
e The 2nd/MAIN switch should be set while the units are
e It is impossible to activate the relay play by connecting
in the power-off mode.
the DIGITAL OUT terminals to each other.
e When the units are not connected to each other, the
"2nd/MAIN" switch on the rear panel of each unit should
be set to the "MAIN" position.
If the power of both the units is set on simultaneously, you can begin play from the first disc in the main unit. The
operating methods are the same as the normai disc play.
In the "SINGLE" disc play-mode
in the "ALL" disc play-mode
Discs are played alternately between the two units in
After playing all discs in one unit, play will be switched to
sequence.
the other automatically.
2
3
4
5
1
[MAIN]
GD ст ст GD CoD
15
Advertisement
Table of Contents
