Table of Contents
Advertisement
3. Slide a braid clamp over the shield so that its inner shoulder
butts against the cable jacket. Then, fold the shield back over
the braid clamp and trim below the shoulder.
Note: Placement of shield wires over the braid clamp must be
uniform to provide good radio frequency connection of the
shield, and to prevent breaking the shield strands.
4. Cut the cable core and the conductor insulation to the
dimensions shown. Do not nick the conductors or the insulation.
If the shield is frayed, trim the shield again as in step 2.
36
Preparing to Install Your Work Stations - 5364
Advertisement
Table of Contents
