b. For each work station attached to the remote controller,
copy the information from the Setup Form.
Note: A boxed arrow pointing to the
right indicates socket 2. A boxed arrow
pointing to the left indicates socket 1.
Name
Glen
+j
Form H1
Device Tvoe
5251-11
}
Name
Glen
>--~~~~~D~e~v~ic~e~T~~e~_,_5_2_5~1-_1_1~~-<
Location
Accountin_q_
Work Station Address
0
Unit Address
00
K~board
Code
00
Telephone
L
/
Does not apply
o System/36.
Vt
8
~~~~~~~~~~~--1
0
1
Look at the keyboard code box
on the remote setup form.
If you see a 2-digit code, check ( ./) the display box.
If the keyboard code box is blank, check (v') the printer box.
AAQ004-1
c. Copy the appropriate device codes (from the chart in step le
for local work stations) onto the diagram.
Assigning Work Station Addresses
11