Table of Contents
Advertisement
1.
When each label has been completed and each cable identified,
fasten the appropriate signal cable labels to each end of the
cable:
a. Peel off the label.
Connect this end to
Device type/name
Location
Work station address
D
Other end conne
Device type/name
Location
Socket/port
Socket/port
0
0
R9477006-1
b. Make sure the black bar on the label is positioned near the
connector end and properly aligned on the center of the
cable.
Connector
rd
Black Bar
/Aligned
Other end connects
to·
Device type/name
Device type/name
Location
Location
Work station address
D
Socket/ port
Socket/port
0
0
'Aligned
R9477007-2
c. Fold the label over and press the ends together.
26
Preparing to Install Your Work Stations - 5364
Advertisement
Table of Contents
