DCCconcepts Super Panel Setup page 8

Please note: This command stream use the
opposite action in the HIGH column when entering data in the LOW column, or vice versa.
See the bottom of Page 39 - 7.1 ACCY - 1 = Accessory Number in the full Super Panel User Guide
for more information on how to achieve this.
You have now setup your first switch to an input to control a digital accessory
on your Super Panel! We will now move on to some more complex solutions.
Sample 1 - DCCconcepts Parts List
Qty Part No
1 x Super Panel
1 x DCD-ATS
1 x DCP-CB1DiP Cobalt iP Digital Point Motor Single Pack
2 x DCD-ACL
1 x Left or right hand point - various makes can be used
Various cable and connectors
Don't forget, you will also need an NCE system, either a PowerCab or
PowerPro, to be able to program and run the SuperPanel.
This has been an extract from a forth coming user
guide on Point Motor Control, in which we will show
you how to use various switches to control various
point motors in common model railway situations.
Please don't hesitate to contact us with any
questions on or about Super Panel.
ADD
Description
Super Panel Control Board
Alpha Toggle Switch 6-Pack of On-Off-On Sprung
Toggle Switches
RJ12 6pin Curly Cord For NCE Powercab and Cobalt
Alpha
DCCconcepts Super Panel Point Motor Control Manual V1.0 March 2024
key instead of the ENTER key to duplicate the