Minolta MN5KGP1 Manual page 43

. Using Your Camcorder
2.8 Interval Photo
In the Interval Photo mode, the camcorder will take a single photo at a set
time interval until stopped.
To enter Interval Photo mode, power the camcorder on and press the
POWER/MODE button to access the mode selection screen and use the UP
or DOWN buttons to select Time-Lapse Photo icon and press the OK button
to enter that mode.
1. Line up your shot by looking at the LCD screen to see what is in the shot.
2. Hold the camcorder steady and press the SHUTTER button to capture a
photo and start the countdown.
3. At the end of each countdown, a new photo will be captured, each
captured photo will be saved as an individual file.
4. To stop the camcorder from capturing any additional images, press the
SHUTTER button.
5. The number of photos that can be captured at a particular resolution will
be displayed at the bottom right corner of the screen.
6. The number of pictures remaining will be 0 if there is no memory card
will be shown on the screen when the memory card is full.
7. The number of remaining photos is determined by the selected photo
resolution. The higher the photo resolution, the lower the number of
photos you are able to be save to the memory card. Before capturing any
photos, you can select a preferred photo resolution.
Your camcorder comes preset with some user-adjustable settings to fine tune
and customize how you would like your videos to be captured. The settings
are already optimized and preset for the easiest experience.
From the main screen, press and hold the OK button until you see the
settings menu on the screen. You can also tap the screen and then select the
gear icon that shows on the screen to access the settings.
2.8.1 Interval
This function allows you to set the amount of time in between images.
42