Self Timer - Minolta MN5KGP1 Manual

. Using Your Camcorder
2.6

Self Timer

In Self Timer mode, the camcorder will take a single picture after a set
amount of time has elapsed with each press of the SHUTTER button.
To enter Self Timer mode, power the camcorder on and press the
POWER/MODE button to access the mode selection screen and use the UP
or DOWN buttons to select the self timer icon and press the OK button to
enter that mode.
1. Line up your shot by looking at the LCD screen to see what is in the shot.
2. Hold the camcorder steady and press the SHUTTER button to start a
countdown, when the countdown ends, a picture is captured.
3. The number of photos that can be captured at a particular resolution will
be displayed at the bottom right corner of the screen.
4. The number of pictures remaining will be 0 if there is no memory card
will be shown on the screen when the memory card is full.
5. The number of remaining photos is determined by the selected photo
resolution. The higher the photo resolution, the lower the number of
photos you are able to be save to the memory card. Before capturing any
photos, you can select a preferred photo resolution.
Your camcorder comes preset with some user-adjustable settings to fine tune
and customize how you would like your videos to be captured. The settings
are already optimized and preset for the easiest experience.
From the main screen, press and hold the OK button until you see the
settings menu on the screen. You can also tap the screen and then select the
gear icon that shows on the screen to access the settings.
2.6.1 Self Timer
This function determines the time delay before a photograph is captured. This
setting can be used by photographers to take photographs of themselves.
1. In Self Timer Mode press and hold the OK button.
2. Select Self Timer using the UP or DOWN buttons.
3. Press the OK button to enter the Self Timer submenu.
32