Installing The Cables For Watchdog Functionality - Matrox Morphis QxT Installation And Hardware Reference

20 Chapter 2: Hardware installation
Installing the cables for Watchdog
functionality
Watchdog functionality is available on the Matrox Morphis QxT board. If
Watchdog functionality is required:
1. Create a custom cable (Cable A) with a standard, 0.1" spacing, 2-pin female
connector at one end, and at the other end, a connector that fits into the Reset
button connector of the chassis (see the System reset connector subsection of the
Base board input and output connectors section, in Appendix B: Technical
information).
2. Create a second custom cable (Cable B) with a standard, 0.1" spacing, 2-pin female
connector at one end, and at the other end, a connector that fits into the
motherboard reset connector (see the above-mentioned subsection).
3. Disconnect the end of the reset button cable currently attached to the reset button
connector of the chassis, and attach Cable A to this connector instead.
4. Disconnect the end of the Reset button cable currently attached to your
motherboard reset connector, and attach Cable B to this connector instead.
5. Connect Cable A to pins 3 and 4 of connector J4 of Matrox Morphis QxT.
6. Connect Cable B to pins 1 and 2 of connector J4 of Matrox Morphis QxT.
1 2 3 4