Table of Contents
Advertisement
If necessary, remove boards from your computer to make room for your Matrox
Morphis QxT board(s).
3. If present, remove the blank metal plate located at the back of the selected slots.
Keep the removed screws; you will need them to fasten the Matrox Morphis QxT
boards.
4. If Watchdog functionality is required, install the appropriate cables as described
in the Installing the cables for Watchdog functionality section, later in this chapter.
5. Carefully position the Matrox Morphis QxT base board in the selected empty
PCIe slot. Once perfectly aligned with the slot's connector, press the board firmly
but carefully into the connector. Anchor the board by replacing the screw that you
removed.
6. If required, install your Matrox Morphis QxT Digital I/O module as described in
the Installing the Matrox Morphis QxT Digital I/O module section later in this
chapter.
7. Attach your video sources as described in the Connecting devices to Matrox
Morphis QxT section, later in this chapter.
8. Turn on your computer.
❖ When you boot your computer under Microsoft Windows, Windows'
Plug-and-Play system will detect a new PCI Data Acquisition and Signal
Processing Controller and you will be asked to assign it a driver. At this point, you
should click on Cancel because the driver will be installed during the installation
of Matrox Morphis QxT software.
Installing Matrox Morphis QxT
19
Advertisement
Table of Contents
