Regulatory Compliance - Matrox Indio Installation And Hardware Reference

Regulatory compliance

Note the following about the Matrox hardware products supported by this guide:
• They comply with Class B limits of FCC and CISPR11.
• They have undergone testing in a typical Host computer of the same class.
• They have undergone testing for measurement, control, and laboratory use, in an industrial
environment.
• They are recommended to be used with shielded cables, although not necessary.
FCC Compliance Statement
Remark for the Matrox hardware products supported by this guide
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment causes harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.
The user is advised that any equipment changes or modifications not expressly approved by the party responsible
for compliance would void the compliance to FCC regulations and therefore, the user's authority to operate the
equipment.