Hover-1 Epsilon Operation Manual page 20

CHARGING YOUR EPSILON
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris, or dirt inside the port.
• Plug the charger into a grounded wall outlet. The charging indicator light
on the charger will be green.
• Connect the charging cable to the power supply (100V 240V; 50 Hz/60
Hz).
• Align and connect the 3-pin charging cable into the charging port of the
Epsilon. DO NOT FORCE THE CHARGER INTO THE CHARGING PORT, AS
THIS MAY CAUSE THE PRONGS TO BREAK OFF OR CAUSE PERMANENT
DAMAGE TO THE CHARGING PORT.
• Once attached to the hoverboard, the charging indicator light on the
charger should change to red, indicating that your device is now being
charged.
• When the red light on your charger turns to green, then your
hoverboard is fully charged. A full charge may take up to 5 hours. While
charging, you will see a red light.
• If you charge the hoverboard while it is powered on, you will see a white
lashing light on the hoverboard that indicates it is charging.
• After fully charging your Epsilon, unplug the charger from your Epsilon
and the power outlet.
WARNING
WARNING
When the Epsilon turns o during a safety
alert, all operation systems will halt. Do not
attempt to ride the Epsilon when the
system initiates a stop. Turn your Epsilon
o and back on to unlock it from a safety
lock.
18