Yamaha MFC10 Owner's Manual page 24

4
Press [FC EDIT], to edit the selected data type (the lamp
flashes) of the parameters set in the above procedure. It is
possible to edit the following types of data.
• Control Change (b) [STATUS=b0-bF]
DATA/CTRL
BANK MSB/MAX
BANK LSB/MIN
• After Touch (d) [STATUS=d0-dF]
DATA/CTRL
BANK MSB/MAX
BANK LSB/MIN
• Pitch Bend (E) STATUS=E0-EF]
DATA/CTRL
BANK MSB/MAX
BANK LSB/MIN
* The value of the Pitch Bend's center pitch is 64.
5
Edit the parameters using the [INC/YES] or [DEC/NO]
buttons.
6
After the desired parameters have been edited in steps
press [WRITE/EXIT]. The Foot Controller's number will flash
in the LED display.
7
Press [INC/YES] to execute the save operation or [DEC/NO]
to cancel.
• Another Memory Number can be easily edited by pressing [1]-[5] without exiting from the edit mode. You
must execute or cancel the save operation for the currently edited data (the current Memory Number will
flash) before proceeding to edit the new number. Use [INC/YES] to execute or [DEC/NO] to cancel the
save operation. If data has not been edited, the Memory Number will not flash and the newly selected
Memory Number will be shown in the display.
About Foot Switch Use
Foot switches can also be connected to the [FOOT CONTROLLER/SWITCH 2-5]
jacks located on the rear panel of the MFC10.
If a foot switch is connected, the set BANK MSB/MAX value will be transmitted via
MIDI when the foot switch is pressed. When the foot switch is released, the set
BANK LSB/MIN value will be transmitted via MIDI.
001-031, 033-120 Control Number
000-127 MAX Value
000-127 MIN Value
– – –
000-127 MAX Value
000-127 MIN Value
– – –
000-127 Pitch Bend MAX
*
000-127 Pitch Bend MIN
FC
EDIT
~
b0 bF
~
d0 dF
~
E0 EF
DEC INC
±10
/NO /YES
4 5
and ,
DEC INC
±10
/NO /YES
Foot Controller
STATUS BANK MSB/MAX
DATA/CTRL
BANK LSB/MIN
TOGGLE ON-OFF
/NUMBER OF PGM
DEC INC
±10
/NO /YES
FC1
DEC INC
±10
/NO /YES
23