Generator Assembly And Mounting - DUROMAX XP4400 Owner's Manual

not start Spark plug is broken.
(continued
Generator is not on level
from page
surface.
19)
Oil is low
Circuit breaker is off.
Engine
runs but
there is no Bad connecting wires/cables.
electrical
Bad electrical device
output
connected to generator.
Generator
Generator is overloaded
runs but
does not
Shorten one of the connected
support all
devices.
electrical
devices
Air cleaner is dirty.
connected.

GENERATOR ASSEMBLY AND MOUNTING

Generator is supplied with a wheel kit. If you want to install the wheel kit on your unit, please
follow the instructions below. If you will not be using the wheel kit, skip this section.
1. Place the bottom of the generator cradle on a flat, even surface. Temporarily place
unit on blocks to ease assembly.
2. Secure the support leg to the cradle with cap screws (M8 x 16) and lock nuts (M8)
(see figure 22 ).
3. Secure the axle to the cradle with cap screws (M8 x 16) and lock nuts (M8) (see figure
23).
4. Slide a wheel over the axle, then secure the wheel with a retaining pin.
(see figure 24,Figure 25, Figure 26).
5. Position the handles on the cradle and attach, cap screws (M8 x 16) and lock nuts (M8)
( Figure 27,Figure 28).
6. Check that all fasteners are tight.
Figure 22
Replace spark plug.
Move generator to a level surface to
prevent low oil shutdown from
triggering.
Add or replace oil.
Set the circuit breaker to the "ON"
position.
If you are using an extension cord,
try a different one.
Try connecting a different device.
Try connecting fewer electrical loads
to the generator.
Try disconnecting any faulty or
short-circuited electrical loads.
Clean or replace air cleaner.
Figure 23 Figure 24