Yamaha LS9 Editor Owner's Manual page 33

H KNEE
Specifies the sharpness at which the output level will change. You can select from HARD or 1–5.
I ATTACK
Specifies the time from when the key-in signal exceeds the threshold level until the signal starts being compressed.
J GAIN
Adjusts the gain of the signal after it has passed through the compressor.
K
RELEASE
Specifies the time from when the key-in signal falls below the threshold level until compression is removed.
L
KEY IN SOURCE
Click this to select the key-in signal that you want to use.
The choices are the same as for GATE.
If COMPANDER-H, COMPANDER-S is selected
4
A TYPE
Indicates the type of the currently selected compressor. You can click here to select the type.
B LIBRARY
This button accesses the dynamics library. Clicking this button will open the DYNAMICS page of the LIBRARY
window.
C ON
This button switches the compressor on/off.
D Response curve
Indicates the response for the compander of the currently selected channel.
E
GR meter
This meter indicates the amount of gain reduction produced by the compressor.
F
THRESHOLD
Specifies the threshold level at which the compressor will operate. The input signal will start being compressed
when the key-in signal exceeds this level; compression will be removed when the signal falls below this level.
G
RATIO
Specifies the ratio at which the input signal will be compressed when the key-in signal exceeds the threshold.
H
WIDTH
Specifies the width between the threshold level of the compressor (THRESHOLD) and the threshold level of the
expander. The expander effect will apply to levels below THRESHOLD + WIDTH.
5 1
33
2 3
6
7
8
9
J
K
L
LS9 Editor Owner's Manual