Panasonic KXL-RW10A Operating Instructions Manual page 37

Troubleshooting
If trouble occurs, check the following points before returning the drive for service.
Your computer S Users for Notebook/Desktop computer with the supplied
does not recognize interface card:
the drive, or does | The Auto Protect function of AC
not function adaptor is working.
properly.
Disconnect the AC adaptor
and connect it again after
2-3 minutes.
The mode of interface card
does not match the mode of
your computer's PCMCIA
socket.
If you wish to use CardBus
mode, make sure that your
computer's PCMCIA socket
supports CardBus mode.
Your computer has not been
setup yet.
Set up your computer. (install
the device drivers, if itis
necessary.) Refer to the
enclosed Setup Manual.
The interface cable or interface
card is not connected to the
drive or to your computer
properly.
The interface cable pin is bent | Consult your dealer (or
or broken. contact Panasonic Service
Center at 1-800-PANA-SYS
for users in continental United
States).
Turn on the drive and reset
your computer. (refer to "Help"
file (3 P. 12, 18) or
"README. TXT' file (= P. 23)
in the enclosed Setup Manual.
Properly connect the interface
cable or interface card
(ΠP. 22).
The drive is off.
@ Users for Desktop computer with SCSI board:
The Auto Protect function of AC | Disconnect the AC adaptor
adaptor is working. and connect it again after
2-3 minutes.
Your computer has not been Refer to "Setting Up Your
setup yet. Desktop Computer" (rs P. 25).
The drive was turned on after Turn on the drive first and
turning on your computer. then turn on your computer. :
(continued)
37